i am trying to use xplotter on a windows system to then move the drive over to a linux miner (i am using raspberry pi) but when ever i try to use xplotter my system says xplotter isnt responding, i am running windows 7

@Wallet1 i realized this a little after i posted but thanks, i will probably have more questions soon.

i am trying out the raspberry pi creepminer, im most of the wat thought set up and when it says use make to compile, im assumming type this in the terminal it says, make: *** No targets specified and no makefile found. Stop.
pls help

hey i am wondering, how many faucets are out there?
pls donate

im a noob to this too and i started yesterday and accidently created like three accounts because i was hand typing the passphrase in and misspelled it and i posted asking for a few burst on like three accounts accidently.... im a noob

hey im new to this just to be clear, all of this is being run on raspbian, right

im just a poor miner getting started pls donate
BURST-XDK7-DKP7-4P6F-6RGPY
seruilsy though i am doing this as an experiment and i am using a raspberry pi, if i plot about 128 gigs about how much would i earn i think like 60 cents a month?

how do i confirm transactions? pls sent some burst
BURST-JX6A-8GER-74D7-DCDND

same looking for help accidently spend faucet coin pls sent few so i can start mining.
BURST-JX6A-8GER-74D7-DCDND

@tminer0315 nevermind my last post i did not have any burst yet to secure account pls send to new address,
BURST-JX6A-8GER-74D7-DCDND