@progryu009gaijin

Thanks again!

I'll be mining tomorrow i think then :)

@progryu009gaijin

Oh so i don't have to do an optimize run after the initial plotting? i have watched the youtubes of imineblocks and he was talking about an optimize run to increase read speeds after the wallet plotted.

@socalguy

I think i got it, i started plotting the 1TB and it started at 500000001 and is going right now. my test plot started at 900047041 because it is on another drive correct?

Once that is done, i will start to plot the 4TB and the wallet AIO will start plotting after the last nonce used from the first 1TB plot.

Once the 4TB plot is done, i can add another drive whenever i want, and it will pick up again where the 4TB last nonce has been plotted.

Is it smart of me to instead of doing the whole 4TB, doing 1TB on the internal drive, then optimize those plots to the 4TB drive?

so plot 2x 1TB, then optimize the first 1TB to the 4TB drive, write a third plot, and then optimize the second plot to the 4TB etc etc?

@socalguy

That's something i will have to look into. how do i calculate how many nonces i should use in the new plot?

I'm guessing i have to keep track of which nonces i am using on that specific computer right?

For example i want to start plotting at 400000001 and i want to add a 4TB plot, what would my nonce range be?

Sorry if the questions are getting a bit off topic btw, if need be i can start a seperate question somewhere else.

Thanks for the answers guys, really apreciate it.

This is only a test plot to make sure i have everything how it supposed to be. I am currently plotting 1 TB, and after that my 4TB drive is up for plot, and already planning on a 8TB one in a week or two :). This 11GB plotm is on a drive that i can't use ( my IP Camera recording drive :) )

I can just add plots and after i hit start mining those will be used as well right? so after my 1TB is done, i restart mining, and when the 4TB is done i restart mining again?

Thanks for the replies in advance!

Hello all

Is this how it should look like when burst mining?

this is my first time mining anything, so i have no clue if i done everything correctly now or if it's not good yet.

Hello guys,

I have recently started burst mining but i am running into some trouble.
i have plotted a 1TB drive, got some burst coins from a nice gentleman on the forums here, and hit "start mining"

The issue i'm running into is that i get error 1004 when it tries to communicate with my pool.

Now i don't know what to do or how to fix this in order to start mining. The error is that "your Burst account's reward recipient () does not match pool's Account (7Z2V-J9CF-NCW9-HWFRY).I have changed from pool.burst.space to pool.burst.eu at first when i got an error 1014, but now this arises here, i have waited the 4 block ( 16 minutes ).

When i changed the pool, at the end it gave me a signaturehash in the window. and i'm not sure if everything went as it should be. Anyone here willing to lend me a hand to get started?

Kind regards,
Andreas

@socalguy

Thanks very much! anyone got an idea how long it takes to download blockchains? or if you can point me into the direction to read more about it, would be apreciated :)

Heya guys,

I set up my first 1TB for burst mining, but can't get any faucet coins to change to a pool, any of you kind people willing to spare me 1-2 to get started? BURST-8KEH-B42S-AWJQ-BARQB would be my wallet. Thanks in advance!