Thanks all for quick answer.

I have created manually as: F: drive. F:\burst\plots

Problem is solved.

Now going to plot 3 TB :)

@ccminer : Same error.

Even i opened a brand new Burstcoin wallet. I thought this could solve issue. No Help.

Hello,

I was plotting 3 TB and due to my mistake power went off. It was 15% completed. After that i decided to delete all files and start over again. I just went to D drive where 3 TB was located and deleted all burst files.

After that running the same bat file "[ERROR] Unable to open plots file" message appeared.

Now, to figure out problem, took small HDD and set up configuration are as below:

HDD size: 149 GB
devices file: 0 0 1024 256 8192
Start bat: gpuPlotGenerator generate buffer F:\burst\plots\8768351084437044327_0_606208_16384 (by the way \ and / both i tried)

Expecting some expert advice!

I am pritty much new in coin mining field, but been mining Burstcoin using 6TB hard drive since couple of days.

Q1: does the burstcoin mining performance reduced if we mine Etherium and burst togethere? I am asking it because few days before i just started mining Etherium using same computer. My earning is dropping day by day! (check attached file)

Q2: What does "confirmed DL" means? Is that a share for me?

Thank you in advance!