up and running but....



  • No plots yet? jminer will not plot. You need xplotter for this. Takes a while to get a drive completely plotted, so take a seat and get some cold drinks.

    The AIO wallet will run xplotter for you, if you want to. There is some teenie text (4- 6 pt font or less) in the bottom left margin that reads "Write Plots". Click on this, then select your drive. It should star right up, writing optimized plots.

    Like I said, it takes a while to get the whole drive plotted. However, you can start mining as soon as xplotter gets going. You may not have a lot of DLs, though, until some reasonable portion of your drive is plotted.



  • ahh.... i thought jminer would also do some plotting :-D

    i guess this explains this:

    2017-06-23 22:40:11.055 INFO 6556 --- [ roundPool-1] burstcoin.jminer.JMinerCommandLine : START block '374306', scoopNumber '3458', capacity '0 GB'
    2017-06-23 22:40:11.056 INFO 6556 --- [ roundPool-1] burstcoin.jminer.JMinerCommandLine : targetDeadline '2592000', baseTarget '448546'

    ie 0 GB



  • even if i use the AIO to run xplotter and move the plot file to the path set in jminer config it does still say the same... hmmm

    i tried to make it list the plot files and it did not list any....



  • plotPaths=C:\Jminer\plots2
    scanPathsEveryRound=true
    listPlotFiles=true


  • admin

    @boelle change your plotPaths statement, should be: plotPaths=c:/jminer/plots2



  • tried that too

    i even switched to jminer 0.4.8



  • 2017-06-23 23:07:41.333 INFO 4312 --- [ roundPool-1] burstcoin.jminer.JMinerCommandLine : START block '374313', scoopNumber '98', capacity '0 GB'
    2017-06-23 23:07:41.333 INFO 4312 --- [ roundPool-1] burstcoin.jminer.JMinerCommandLine : targetDeadline '2592000', baseTarget '402867'

    also it does not list the plot files as i have told it to



  • dooooh..... haitch pointed out that i have used the wrong num account... not sure how i screwed that up

    jminer is now running

    now are there downsides to use small plots of say 2gb compared to 52gb ones?



  • Those are both really small.

    That being said, bigger is better. Not really sure what kind of results you'll get with a 52gb plot. It may be too small.



  • i come from the distributed computing world where its perfecty ok to use small blocks of work as long you have a permanent connection to internet

    it will just fetch work more often



  • btw.... can jminer be configured for more than one device?

    currently i have it set for GPU but what about both GPU and CPU.. ie at night when sleeping



  • I do not know. I think jminer uses your GPU. You can use your CPU for plotting, but not jminer. You can plot with xplotter.

    I hope this helps.


Log in to reply
 

Looks like your connection to Burst - Efficient HDD Mining was lost, please wait while we try to reconnect.