Plotting Problem
-
yes only the sn. it equals last nonce number plus 1 nonce.
the last nonce number is highest of your set. its starting nonce then add its nonces equals last nonce number. add one nonce to that is the input sn. important to add one nonce for input sn as not to overlap. observe your plots to find the highest nonce number is the last plot of the set. sorry i cannot determine your last plot number squint squint
-
I tried to put the plotfiles into a chronological order. The problem is , that the creation data is not similar to the optimization data
http://fs5.directupload.net/images/170517/d8l7skfu.jpg
The green buttons are the optimized plots and the 2 blue buttons are the unoptimized plots
-
And now i dont understand , at which nonce i can go further ?
-
http://www.bilder-upload.eu/show.php?file=6281dc-1494983905.jpg
This is the problem my miner shows to me
The path G:\Burst\plots is the new plotted hdd
-
@Hanftychoon At some point you changed your drive letters, this messed up the AIO. Delete the plot file on G: and replot.
-
@haitch at first thank you very much for your help
iam now plotting the path G again and now it looks like this
http://www.bilder-upload.eu/show.php?file=7da894-1495022230.jpg
I see that it changed the start nonce number to 700000001_******.....
Is that correct now ?
-
@Hanftychoon yes. Also if you run plotter as Admin - plotting will much faster
-
@Blago 13years old pc
-
http://www.bilder-upload.eu/show.php?file=e718ad-1495274968.jpg
when i want to plot the hdd Neu 7 (J:) the xplotter begins at 10000000**** which is the wrong start noncehttp://www.bilder-upload.eu/show.php?file=eae925-1495278414.jpg
These files are all my actually plotfiles , the red marked are in optimizetion process at the moment
-
@Hanftychoon plotter begins by start_nonce which you set in bat file (-sn parameter)
-
i know , i already got some help from @luxe
