[Solved] Plotting with XPlotter - The minner not recognize my plots or the path.
-
Hi guys, this morning i just did a test with the xplotter, cuz i noticed or i read it plots and at the same time it optimize ur plots, so i think that's amazing.
The thing is.. my wallet didnt get the new plots. And as i see, when i plot with the AIO wallet, 0.3.9.2 the folder when the plots goes, have another folders, not in the same folder, but in a folder before, like this
Instead, after ploting with xplotter, i have just the plots folder, without any other folders before.
And yeah the thing is , seems like my minner dont recognize the new plots.
This was the settings for the xplotter i used.
XPlotter_avx.exe -id 10388149631738753214 -sn 0 -n 0 -t 4 -path X:\plots -mem 7G
Did u guys what's going on? Thanks you!..
-
you need to add X:\plots to your miner config file, miner.conf
-
@IIOBrocker %AppData%\BurstWallet\miner-burst-1.160705\miner.conf
-
@Blago Hi guys thanks, i have another question, ploting with the AIO 0.3.9.2 it plots and optimize the plots too?
-
@IIOBrocker XPlotter uses by default
-
This post is deleted!
-
@IIOBrocker said in [Solved] Plotting with XPlotter - The minner not recognize my plots or the path.:
XPlotter_avx.exe -id 10388149631738753214 -sn 0 -n 0 -t 4 -path X:\plots -mem 7G
did you plot a ZERO file? try increasing "-n" value to more than 0 (usually the free space on the drives need plotting)
Yes, Xplotter produce optimized plots by default.
-
@rnahlawi -n 0 tells xplotter to use the whole drive.
-
@haitch oh, didnt know that :)


