Pool question
-
@Xander52 Multiple PC's are fine, you'll just need to manually plot the files to ensure no overlaps.
-
@haitch OK as long as I just use 1 plot per drive its fine though right (or does each consecutive drives starting nonce need to be one higher than the previous drives ending nonce?)
-
@Xander52 I guess you should of asked me ! I recently raised the minimum payout to 40 burst to take some pressure off the code.
-
@tross Why did my burst just vanish though? Noob mistake? My address is BURST-2X2W-R2T5-ULL7-5VVP7 if you need it
-
@Xander52 If you use the All In One miner, it will start plotting nonces based off the PC's drive letter - so plot 1 on PC 1 on drive C, will contain the same nonces as Plot 1 on Drive C of PC2. You need to manually do them.
PC1 - plot 1 - start at 0 do X
PC1 - Plot 2 - start at X do X1
PC2 - Plot 1 - start at X + X1 do X2
PC2 - Plot 2 - start at X + X1 + X2 do X3
......
-
@haitch OK thanks.
-
@Xander52 said in Pool question:
BURST-2X2W-R2T5-ULL7-5VVP7
"3663532852935423004": 15.55, is what I found in pending json. Like I said and posted on site I had to raise payouts from 20 burst to 40 bust. Good luck!
-
@haitch OK now .eu is saying that my nonces are too long, is there an option to tell uray miner to only submit shorter nonces?
-
@Xander52 Not on Urays as far as I know. Are you on 32 Bit windows? If 64 bit, switch to Blago or jMiner.
-
@haitch I am on 64bit linux and I went back to tross's pool
-
@Xander52 you should be able to use the GPU assisted jMiner on Linux.
-
@Xander52 check out dpreyls mod for urays miner in the software section.

