Plotting my external 3TB Hard Drive
-
As you can see my snap image 98 percent calculated writing data has Not change at all more than 8 hours ago. Does this means somehow it got corrupted. Also, on the right side my CPU readings are running smoothly. Should I stop the plotting process and start all over again?
-
@Ramon32842016 Check the properties of the drive - I think you'll find there is close to 0 Bytes free - I suspect you've tried to plot slightly more space than your disk actually has - that causes the plotter to hand right at the end. If that is the case, terminate the plotting, then run plotschecker.exe from the Software area against the plot to correct it.
-
@haitch Can you please guide me with some steps how to run plotschecker.exe?
-
@Ramon32842016 example, you are running it on your F: drive. : plotschecker.exe f:\Burst\plots
