Windows plotter stuck on 99%
-
Hello everyone. I'm plotting 5TB hard drive and today it stuck on 99 percent. It took ages to get to this point and now I don't wanna do it all from the beginning. Any solution Pls?
-
@westcity You probably got your nonce calculation wrong, and the plotter has 100% filled the drive. Check the properties of the drive - if there are 0 bytes free, kill the plotter then run the plotchecker util from the Burst Software section.
-
@haitch It says 5.25 MB, Should I still run the pChecker?
-
@westcity yep. 5.25MB is less than your stagger - the plotter can't write it. Kill the plotter, run the plotchecker.
-
@haitch Thanks a lot for help. All sorted and running well. Yes you were totally right about the problem. Thank you again :)
